Gorenje NRF7181TX Guide D'utilisation page 36

BEFORE CALLING SERVICE
Are door gaskets broken or torn?
Is your fridge on a level surface?
If the edges of fridge cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact
may get warmer during the operation of the compressor, this is normal.
IMPORTANT NOTES:
Compressor protection thermal fuse will be blown after sudden power
breakdowns or after unplugging the appliance, because the gas in the
cooling system is not stabilized yet. Your fridge will start after 4 or 5
minutes, there is nothing to worry about.
The cooling unit of your refrigerator is hidden in the rear wall. Therefore,
water droplets or icing may occur on the rear surface of your fridge
normal. There is no need to perform a defrosting operation unless the
If you will not use your fridge for a long time (e.g. in summer holidays),
unplug it. After defrosting, clean your fridge and leave the door open
to prevent humidity and smell.
If the problem persists after you have followed all the instructions
above, please consult to the nearest Authorized Service.
The appliance you have purchased is designed for home type use
and can be used only at home and for the stated purposes. It is
not suitable for commercial or common use. If the consumer use
the appliance in a way that does not comply with these features, we
emphasize that the producer and the dealer shall not be responsible
for any repair and failure within the guarantee period.
Comformity Information
This appliance is designed for use at an ambient tem-perature within
the 16°C - 43°C range.
The appliance is designed in compliance with the , IEC60335-1 /
IEC60335-2-24, 2004/108/EC standards.
EN
35