Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
PROBLEM
THINGS TO CHECK
The vacuum sealer
Drip tray is clogged.
is not working.
Press pads are obstructed.
Noise is present.
Bag has not been placed flatly and
smoothly over the sealing area.
Zipper is not closed completely.
Parts are missing or incorrectly
installed.
The vacuum sealer
LED is on and green.
is not working.
Bag sensor is engaged.
Noise is not
present.
Lid is closed and locked.
Bag is leaking.
Zipper is not closed completely.
Safety precautions:
Maintenance:
Clean the product only with a dry cloth.
Do not use cleaning solvents or abrasives.
Warranty:
Any changes and/or modifications to the product will void the warranty. We cannot accept any liability
for damage caused by incorrect use of this product.
Disclaimer:
Designs and specifications are subject to change without notice. All logos, brands and product names
are trademarks or registered trademarks of their respective holders and are hereby recognized as
such.
Attention:
•
This product is designated for separate collection at an appropriate collection point. Do not
dispose of this product with household waste.
•
For more information, contact the retailer or the local authority responsible for waste
management.
SOLUTION
Remove the tray and clean it.
Clear out any food that is in the sealing
area and reposition the bag.
Reposition the bag so that there are no
creases or folds in the sealing area.
Close the zipper securely. Run your fingers
through the zipper top.
Assemble the parts as illustrated on
page 21.
Plug in the AC adaptor.
Reposition the bag using the same hole, so
that the bag sensor is covered.
Put your finger on the dots on the sealer
and push until you hear a "click".
Close the zipper completely. Run your
fingers through the zipper top.
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
7
Publicité
Table des Matières
