Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The appliance must be includ-
ed in an "Equipotential" ground
discharge system.
Drainage of the appliance must
be conveyed into the grey wa-
ter discharge network in an
open "glass" unsiphoned formation.
The appliance must only be
used for the purposes indicat-
ed. Any other use must be
considered "IMPROPER" and there-
fore the manufacturer declines all li-
ability for any consequent damage
to persons or property.
Particular safety prescriptions
(obligation-prohibitions-dan-
ger) are detailed in the specific
chapter concerning these issues.
Do not obstruct the heat ex-
traction
openings.
Do not leave flammable ob-
jects or material near the ap-
pliance.
upstream the appliance whenever
you need to work in safe conditions.
Whenever it is necessary to
operate inside the appliance
(connections, commissioning,
checking operations, etc.) prepare
for the necessary operations (re-
moval of panels, elimination of sup-
ply) in compliance with the safety
conditions.
The appliance has to be in-
stalled and used in such a
way that any water cannot
contact the fat or oil.
DUTIES
AND
TIONS REQUIRED OF OPE-
RATORS
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
and/or
dissipation
Disconnect all sup-
plies if present (e.g
gas
- electrical)
QUALIFICA-
Prohibition for the homogene-
ous operator to perform any
type of operation (mainte-
nance and/or other) without having
first read the entire documentation.
qualified technical operator who is
authorised for: handling, installation
and maintenance of the appliance in
question.
drawn up for the "Generic" operator
(Operator with limited responsibili-
ties and tasks). Person authorised
and employed to operate the ap-
pliance with guards active and ca-
pable of performing routine mainte-
nance (cleaning the appliance).
The operators who use the
appliance must be trained in
all aspects concerning its
functioning and safety features.
They must therefore interact using
appropriate methods and instru-
ments, complying with required
safety standards.
The "Generic" operator must
operate on the appliance after
the technician has completed
installation (transportation, fixing
electrical, water, gas and drain con-
nections).
WORK AREAS
AND HAZARDOUS ZONES /
To better define the scope of inter-
vention and the relevant work zo-
nes, the following classification is
provided:
• Dangerous zone: any zone wi-
thin and/or in proximity to a ma-
chine in which the presence of an
exposed person constitutes a risk
in terms of the health and safety of
- 6 -
The information con-
tained in this document
is for the use of the
The
operating
structions have been
in-
Publicité
Chapitres
Table des Matières
