Assembly Instructions; Fitting Instructions - Altrad Belle PCX 20/45 Manuel De L'opérateur

Paving Pad
The Paving Pad has been designed to be used
when tamping down Paving Slabs and Block
Pavers. However, it should not be used for
normal compaction work.
Before fitting, make sure the Paving Pad you
have is the correct size and the correct type.
The Paving Pad will arrive pre-assembled and
will just need to be fitted to the Plate Compactor.
To fit the Paving Pad (Item 1), place the Pad
under the Plate Compactor ensuring the securing
holes line up with the holes on the front of the
baseplate.
Apply Loctite 262 to the Screw (Item 2) and
secure the Paving Pad using all Fasteners (Items 2-4). Tighten to 50Nm.
Transporter Attachment
The transporter attachment enables the operator to move the compactor to the work place with the minimum of effort.
Removable Transporter Attachment
To fit the transport attachment, align the pivot bracket with the holes on the rear of the baseplate.
The two securing bolts should be passed through the pivot bracket and the baseplate. Tighten to 50Nm.
Slide the wheel frame onto the pivot bracket, tilt the compactor forward then swing the wheel frame forward and under. Finally, tilt the
compactor back and onto the wheels.
Fixed Transporter Attachment
To fit the transport attachment, align the bracket with the holes on the rear of the bedplate. The two securing bolts should be passed
through the bracket and into the bedplate.

Fitting Instructions

2
3
4
28
1