Horizon Fitness T100 Manuel Du Propriétaire page 4

ASSEMBLY STEP 1
HARDWARE BAG 1 CONTENTS :
SCREW (A)
15 mm
Qty: 4
FRAME EXTENSION TUBE
SCREWS (A)
CONSOLE MAST SUPPORT TUBE
6
T100-OM-rev1.2.indd 6-7
Open hardware bag 1.
A
Slide the left frame extension tube onto
B
the console mast support tube. Bolt
in place using 2 screws (a) on the side.
Repeat on the other side.
C
ASSEMBLY STEP 2
HARDWARE BAG 2 CONTENTS :
BOLT (B)
SPRING WASHER (C) FLAT WASHER (D)
15 mm 15 mm 15 mm
Qty: 8 Qty: 8 Qty: 4
CONSOLE CABLE
(THREAD THROUGH
TOP OF CONSOLE MAST)
RIGHT CONSOLE MAST
CONSOLE MAST
SUPPORT TUBE
ARC WASHER (E)
SPRING WASHER (C)
BOLT (B)
FLAT WASHER (D)
SPRING WASHER (C)
BOLT (B)
Open hardware bag 2.
A
Slide the left console mast
B
ARC WASHER (E)
17 mm
down onto the console mast
Qty: 4
support tube. Bolt in place
using 2 bolts (b), 2 spring
washers (c), and 2 flat
washers (d) on the side. Then,
bolt in place using 2 bolts (b), 2
spring washers (c), and 2 arc
washers (e) on the front.
C Repeat on the other side.
On right console mast, the
console cable must be threaded
through the mast.
NOTE: Do not completely tighten any
step 4
screws or bolts until is complete!
NOTE: Be careful not to pinch any wires
while assembling the masts.
7
7/28/10 9:02 AM