Circuit Breaker - Thetford Marine TECMA Nani Premium PLUS Manuel D'installation Et D'utilisation

Installation, Con't.
8
1. Choose installation method.
H
2. Run ; assemble parts as shown.
3. Tighten 2-1/2" 3 to secure in
place.
9
D
DANGER:
Failure to use a Vented
Loop in raw water pump installation sites can
lead to water fl owing into the toilet from the
outside (siphoning) which can cause loss of
property and life! Refer to Installation Planning
Raw Water Considerations"
- "
if a Vented Loop is needed!
Wire Gauge for distance from source*
12 Volts
24 Volts
Wiring to Tank Sensors: 18 gauge*
* Distance measured assumes two wires, power and ground.
www.thetfordmarine.com
Vertical Installation
3
H
10
Test Toilet
BEFORE permanently attaching the toilet:
■ Flush the toilet to check toilet operation.
■ Verify no leaks; correct as needed.
■ Permanently insert
to determine
Tecma Nano Electrical System
Wire Gauge Size Chart
0-20 feet
8 Gauge
0-20 feet
10 Gauge
29
3
3
4A
4B
4C
H
11
and into wall.
K4
K5
20-32 feet
8 Gauge
20-32 feet
10 Gauge
Tecma Nano PREMIUM Owner's & Installation Manual
Horizontal Installation
4A
4B
4C
2
(2x)
1. Caulk along inside of trace line.
1
2
2. Place ; insert into floor; secure.
1
3. Caulk around base.
Caution!
Seal with silicone or latex base
sealant. Do not use Polysulfi de base sealants
that can damage plastic.
33-50 feet

Circuit Breaker

6 Gauge 30 amp
33-50 feet
8 Gauge 20 amp
1