Mounting Location - Thetford Marine TECMA Nani Premium PLUS Manuel D'installation Et D'utilisation

Fig. E
IF NEEDED-8" above
waterline ALL TIMES!
A. Fresh Water Hook-up
K1
B. Raw Water Pump Hook-Up
K4
C. Thetford Water Pump (Raw Water Install)
K8
D. #4 Lower Discharge Check Valve (Vertical)
Filter or Strainer (Raw Water Install)
A1
E. Water Tank (Fresh Water Install)
A
F. Non-Thetford Water Pump (Raw Water
B
Install)
Before starting the installation, consider and plan for the following:

Mounting Location

■ Ideally, the Nano toilet should be installed in a location that is higher than the holding tank. A (maximum) 6' rise between the toilet and holding tank will not impact
performance.
■ Using toilet and supplied template, verify that the installation site has:
• suffi cient clearance between toilet and nearby wall so that water supply hose and discharge hose are not kinked
• room for maintenance accessibility
■ The floor supporting the toilet is level and strong enough to support toilet and weight of any potential user.
■ The floor structure is strong enough to securely anchor toilet using supplied screws; 3/4" minimum.
■ The flooring is water-resistant so structure and anchoring integrity are maintained.
www.thetfordmarine.com
D
C
Floor-minimum 3/4"
K8
OR
B
A1
G. Fresh Water Pressure Pump (Fresh Water
B1
Install)
H. C 3/4" Water Supply (Raw Water Install)
I. C1 1/2" Water Supply (Fresh Water Install)
J. Vented Loop
D
K. Toilet Discharge Hose
E
L. Relay Module
F
25
Orientation
L
K4
E
4
H
G
A
I
M
K1
F
C1
J
K
B1
Fresh Water Install
M. Water Pump Wiring
G
N. Discharge Line (above or below fl oor)
H
O. Holding Tank
I
P. Full Tank Sensor
J
Q. Mid Tank Sensor
K
R. Wall Switch
L
S. M Bezel
Tecma Nano PREMIUM Owner's & Installation Manual
H