Inspection Record - Tractel guard trac Manuel D'installation

14. INSPECTION RECORD

Category No.
1. Installation
1.1
1.2
1.3
1.4
1.5
1.6
1.7
1.8
1.9
1.10
1.11
1.12
1.13
1.14
1.15
1.16
1.17
1.18
1.19
2. Manual 2.1
2.2
3. Marking 3.1
3.2
4. Fill in A
B
C
D
E
F
G
Check:
The correct number of counterweights: 2 on double bracket, 2 on single
bracket, 4 on each double bracket at the bottom of the gate and 4 on the
double bracket at each free end
The presence of the latch on all double brackets.
The presence of the latch on the double bracket at each free end.
The presence of anti-slip pad on single and double brackets.
Locking of gearwheel of the barriers with the latch
The presence of the pin (s) on the adjustable guardrails.
The contact between the lower surface of the gearwheel and the upper
surface of the double bracket tubes.
On guard trac™ plus guardrail that the contact between the lower surface
of the washer on the central upright and the upper surface of the single
bracket tube.
The presence of the parapet.
That the distance between the guardrail and the parapet is 50 mm
minimum.
The presence of the clamping cone and its spring in each single and
double bracket.
The presence of the counterweight interface between each stacked
counterweight.
On guard trac™ plus guardrail that the inter-barrier links are tightened
That the gate closes automatically.
That the 2 handles of the gate are tightened.
The proper assembly of the gate.
The good condition of the counterweights.
That no component is deformed.
The absence of abnormal corrosion.
The good legibility of the manual.
That the inspection sheet is filled in correctly.
That all markings are legible.
The presence of the identification plate of the installation completely
filled in.
Inspector's name.
Date of inspection.
Inspection OK = YES/NO.
Faults eliminated on.
Validation issued on.
Inspector's signature.
Next inspection on = E +1 to mention on the identification plate of the
installation
GB
21