Adjusting The Sound; Setting Bass And Treble - Sonoro LOUNGE SO-320 Mode D'emploi

Resetting the device to the factory settings
Fig.18. Resetting to the factory settings
If necessary, you can reset all specified settings, such as language and time formats
and saved stations, to the default factory settings (Fig.18).
8.4

Adjusting the sound

8.4.1

Setting bass and treble

When the device is switched on, the sound of the audio playback can be adjusted via
the bass and treble controls.
Configuring settings via the remote control
Fig.19. Adjusting the sound
1. Press the [Bass] or [Treble] button on the remote control.
2. To adjust the bass, select [Bass] (Fig.19/ A) and press the [VOL +] or [VOL -] button.
3. To adjust the treble, select [Treble] (Fig.19/B) and press the [VOL +] or [VOL -]
button.
4. Press the [OK] button or wait 10 seconds to confirm the setting.
Configuring settings via the device
1. Press the [SETUP] button in the front of the device.
2. Turn the click wheel until [Bass] or [Treble] is shown.
3. Press the click wheel to confirm your selection.
4. To configure the bass, select [Bass] and turn the click wheel. To configure the
treble, select [Treble] and turn the click wheel.
5. Press the click wheel or wait 10 seconds to confirm the setting.
© sonoro audio GmbH 2018
GB
73