Setting The Sound; Adjusting The Bass And Treble; Alarm Function; Setting The Alarm Time - Sonoro SO-110 Mode D'emploi

4. Adjust the brightness level from 1–8 by turning
the click wheel.
5. Press the click wheel on the device or the [OK]
button on the remote control to confirm the set-
ting.
i
The backlight is adjusted automatically depending
on the ambient lighting.
8.6

Setting the sound

8.6.1 Adjusting the bass and treble

You can adjust the audio playback's sound using the
bass and treble settings when it is switched on.
Adjusting the settings using the remote control
Fig. 22: Setting the sound
1. Press the [Bass] or [Treble] button on the
remote control.
2. To adjust the bass, select [Bass] (Fig. 22/A) and
press the [VOL +] or [VOL ‐] button.
3. To adjust the treble, select [Treble] (Fig. 22/B)
and press the [VOL +] or [VOL ‐] button.
4. Press the [OK] button or wait 10 seconds to con-
firm the setting.
Adjusting settings via the device
1. Press the [MENU] button on the front of the
device.
2. Turn the click wheel until the display shows
[Bass] or [Treble].
3. Press the click wheel to confirm your selection.
4. To adjust the bass, select [Bass] and turn the
click wheel. To adjust the treble, select [Treble]
and turn the click wheel.
5. Press the click wheel or wait 10 seconds to con-
firm the setting.

9 Alarm function

You can use the device to wake up with FM/DAB
radio, Relax Music or alarm ringtones.
All settings are made by pressing and holding the
[Alarm 1] or [Alarm 2] button on the front of the
device or the remote control.
The alarm functions can also be set in the device's
Standby mode.
The alarm setup menu is structured as follows:
'Set the Alarm Time è Set the Alarm Source
è Set the Alarm Volume è Set the Alarm Repetition
è End'
i
If you do not enter any information for approx.
10 seconds when setting the alarm, the setting is
terminated without saving it.
9.1

Setting the alarm time

Fig. 23: Setting Alarm 1
1. Keep the [Alarm 1] or [Alarm 2] button pressed.
ð The display shows the [Alarm 1 Time]
(Fig. 23) or [Alarm 2 Time] menu.
2. Turn the click wheel to set the hours.
3. Press the click wheel to confirm the entry.
ð The minute display flashes.
4. Turn the click wheel to set the minutes.
5. Press the click wheel to confirm the entry.
i
Use the [Next ] or [Previous] button to switch
between the hours and minutes display.
ð The alarm time is set.
9.2

Setting the alarm source

After you have set and confirmed the alarm time, you
can set the source for the alarm (Fig. 24).
87