Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
.
English
•
Always hold the electric power tool with a
firm grip.
•
Exert no force! Push the electric power
tool forwards, gently and evenly.
•
The electric power tool must not be
braked with the hand or by applying lateral
pressure.
•
The safety guard may not be blocked and
must be returned to the starting position
after the final working step.
•
Before use of the electric power tool,
inspect the function of the safety guard
with the tool unplugged from the mains.
•
Before each use of the electric power tool,
make sure that the safety mechanisms
such as the safety guard, flanges and
adjustment devices are functioning and/or
are correctly installed and fastened.
•
A suitable dust extraction system is to be
connected to the dust extraction connec-
tion (10). Make sure that the dust extrac-
tion is correctly and securely attached.
Switching on and off (Figure1)
Switching on:
Push the safety switch (1b) forward with one
finger and then press the On/Off switch (1a)
keeping it pressed.
Switching off:
Let go of the On/Off switch (1a).
Using the laser (Figure 7)
Using the laser beam-guide makes sawing in a
straight line much easier.
a.
Either along a drawn line
b.
Or by aligning the beam to a marked
point
•
To switch the laser (9) on, press the Laser
On/Off switch (11)
•
To switch the laser (9) off, press the Laser
On/Off switch (11) again
Overload protection (Figure 1)
The electric power tool is equipped with an
overload protection. The overload indicator (15)
displays the operating condition of the electric
power tool.
Overload indicator (15) flashing: The electric
power tool is approaching the limiting load
– reduce the forward feed speed.
28
7062244_MaxxSaw_Ma_#1503-19.indb 28
Overload indicator (15) continually lit: The elec-
tric power tool is overloaded or jammed
– the electric power tool cuts out. In this event,
switch the electric power tool off and allow it to
cool down before using it again.
Use
WARNING! Always begin by making
a test cut in a left-over piece.
1.
Firmly clamp small wooden pieces before
commencing work. Never hold them in
your hand.
2.
Fully observe the safety regulations! Wear
safety glasses!
3.
Adjust the cutting depth and rotation
speed.
4.
Pick up the electric power tool and make
sure that none of the ventilation openings
are covered.
5.
Switch on the electric power tool and wait
for several seconds until the tool insert has
attained its full rotation speed.
6.
The waste piece should be on the right or
left side of the electric power tool, so that
the wide part of the supporting table rests
on its entire surface.
7.
The base plate must always rest flat on the
workpiece.
8.
Place the base plate to the marked area
(6) onto the workpiece
9.
Press the release button (12) and slowly
push the tool insert (17) into the workpiece
or, if necessary, plunge it.
10. Push the electric power tool forwards
through the workpiece. Never move it
backwards!
11. Apply only a gentle force to the electric
power tool when working.
12. If sawing along a marked line, lead the
electric power tool along the appropriate
groove.
13. If the overload indicator (15) flashes,
reduce your speed.
14. If the electric power tool stops and the
overload indicator (15) is lit continuously,
then the overload protection of the electric
power tool has responded. Reason: You
were moving forward too quickly or have
encountered an obstacle in the workpiece.
In this case, switch off the electric power
27-08-15 09:42
Publicité
Table des Matières
