Lenze ECS K001 Série Instructions De Montage page 35

Safety instructions 1
General safety and application information
Transport, storage
Please observe the notes on transport, storage, and appropriate handling.
Observe the climatic conditions according to the technical data.
Installation
The capacitor modules must be installed and cooled according to the
regulations given in the corresponding instructions.
Ensure proper handling and avoid excessive mechanical stress. Do not bend any
components and do not change any insulation distances during transport or
handling. Do not touch any electronic components and contacts.
Capacitor modules contain electrostatic sensitive devices which can easily be
damaged by inappropriate handling. Do not damage or destroy any electrical
components since this means hazards for your health!
Electrical connection
When working on live capacitor modules, the valid national regulations for the
prevention of accidents (e. g. VBG 4) must be observed.
The electrical installation must be carried out according to the appropriate
regulations (e.g. cable cross−sections, fuses, PE connection). Additional
information can be obtained from the documentation.
The documentation contains notes for EMC−compliant installation (shielding,
earthing, filters and cable routing). These notes must also be observed when
using CE−marked capacitor modules. The manufacturer of the system or
machine is responsible for the compliance with the limit values required by EMC
legislation.
Operation
If necessary, systems including capacitor modules must be equipped with
additional monitoring and protection devices according to the corresponding
safety regulations (e. g. law on technical equipment, regulations for the
prevention of accidents). The capacitor module can be adapted to your
application. Please observe the corresponding information given in the
documentation.
After the capacitor module has been disconnected from the supply voltage, live
components and power connections must not be touched immediately because
capacitors can be charged. Please observe the corresponding labels on the
capacitor module.
All protection covers and doors must be shut during operation.
Note for UL−approved systems with integrated capacitor modules: UL warnings
are notes that only apply to UL systems. The documentation contains special UL
notes.
l
35
EDKCSEK002 DE/EN/FR 3.0