Electrical Installation; Installation According To Emc (Installation Of A Ce−Typical Drive System) - Lenze ECS K001 Série Instructions De Montage

Installation according to EMC (installation of a CE−typical drive system)
4

Electrical installation

4.1 Installation according to EMC (installation of a CE−typical drive system)
General information
The electromagnetic compatibility of a machine depends on the type of
ƒ
installation and care taken.Especially consider the following:
–
Assembly
–
Filtering
–
Shielding
–
Earthing
For diverging installations, the evaluation of the conformity to the EMC
ƒ
Directive requires a check of the machine or system regarding the EMC
limit values. This for instance applies to:
–
Use of unshielded cables
–
Use of collective interference filters instead of the assigned RFI filters
–
Operating without RFI filters
The compliance of the machine application with the EMC Directive is in
ƒ
the responsibility of the user.
–
If you observe the following measures, you can assume that the
machine will operate without any EMC problems caused by the drive
system, and that compliance with the EMC Directive and the EMC law is
achieved.
–
If devices which do not comply with the CE requirement concerning
noise immunity EN 61000−6−2 are operated close to the ECS modules,
these devices may be electromagnetically affected by the ECS modules.
EDKCSEK002 DE/EN/FR 3.0
Electrical installation
l
4
47