Treated Instruments - MICRO MEGA X-Cid2 Manuel D'utilisation

TREATED INSTRUMENTS

■ ®
The X-Cidol 2 detergent solution penetrates the components and structures of all commercially available
handpieces, contra-angles and turbines, from the bottom to the orifice at the head.
■ For the treatment of straight handpieces, fix them in a locked position in the device so that they do not rotate during the
cleaning process.
Remove all instruments from the handpieces, contra-angles and turbines before cleaning so that the cleaning liquid can easily
penetrate the handpieces, contra-angles and turbines.
■ In case of any doubts, contact your distributor.
■ It is essential to carefully examine your old handpieces, contra-angles and turbines before treating them with the X-Cid
■ If the contra-angle rotates in the device, or if the X-Cid
condition and send it in for service if necessary.
■ The manufacturer reserves the right to modify the construction and characteristics of the device without advance notice.
WARRANTY
■
For any manipulations other than those described above, please contact the service department of your distributor.
2 is guaranteed for 24 months following the installation date against any manufacturing defects, with the
■ The X-Cid ®
exception of damage caused by improper handling or maintenance, the use of unsuitable products or products that are not
recommended by the manufacturer (detergent/disinfectant, demineralised water and oil), non-compliance with the operating
instructions for the device or attempted product modification.
DISPLAYS
Année du marquage CE : 2006
Year of CE-marking: 2006
CE-Kennzeichnung: 2006
®
2 shows repeated motor defects, verify the contra-angle's
®
2.
26
07/13 Ref. 60300544-I