EUROM Safe-t-Shine 1200 Manuel D'utilisation page 27

supplier or a recognised electrician to be checked and/or repaired.
Always ask for original parts to be used.
4. The device may only be opened and/or repaired by a competent
and qualified person. Do not carry our your own repairs as this
could be dangerous! Repairs carried out by unauthorised persons or
changes made to the device could damage the dust/waterproof
capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences.
Description
1. Handle (back)
2. Casing
3. Radiation grill
4. Reflector
5. Halogen lamp (3x400W)
6. Base
7. On/off button
8. Control button (2x)
9. Oscillation button
Assembly, location and connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
The device consists of two parts that you must fit together before use: the actual
device and the base (6).
 Lead the electrical cable with plug through the middle hole
in the base; from top to bottom (the hollow side of the base
is the underside).
 Now slide the base over the small white box with the
electrical cable on the underside of the device: all hollow
spaces and protrusions and screw holes on top of each
other. It only fits in one way.
 Now firmly fasten the base and the device together using
27