Using The Appliance; Fitting/Removing The Attachments; Epilation - SilverCrest SBT 3.6 B1 Mode D'emploi

■ Before epilation, treat the skin with a peeling treatment or a massage glove. This
helps remove dead skin cells, ingrowing hairs are avoided, and fine hairs stand
proud. This enables the appliance to grip the hairs better.
■ After epilation/shaving, treat the skin with a moisturising lotion or cream. Ideally, use
a cream containing aloe vera or camomile extracts to soothe and maintain the skin.

Using the appliance

Fitting/removing the attachments

All of the supplied attachments (epilator head
and micro trimmer
orientation of the attachment to the hand element
The curvature of the attachments must always be towards the side of the hand element
on which the on/off button
♦ To fit an attachment, press it onto the appliance (see Fig. 1)
♦ To remove an attachment, pull it off the appliance (see Fig. 2)

Epilation

When the appliance is charged and the body part to be epilated is prepared:
1) Rub your hand once more against the growth direction of the hairs to be removed.
This will raise the hairs so that they can be better captured by the tweezers.
2) Fit the epilator head
head must be facing towards the side of the hand element
off button is located (see chapter "Fitting/removing the attachments").
3) Push the on/off switch
4) Hold the skin tight with one hand.
│
■ 56 GB
) can be fitted and removed in the same manner. Ensure the correct
is located.
(Fig. 1)
on the hand element
in the direction of the attachment.
, precision trimmer
:
. The slight curvature of the epilator
, micro shaver
;
(Fig. 2)
on which the on/
SBT 3.6 B1