Promise Technology VessJBOD 1730 Guide De Démarrage Rapide page 8

VessJBOD 1000 Series Quick Start Guide
3. Insert the screws through the holes in the drive carrier and into the sides of
the disk drive.
• Install only the counter-sink screws supplied with the VessJBOD.
• Install four screws per drive.
• Snug each screw. Be careful not to over-tighten.
4. Reinstall the drive carrier into the VessJBOD chassis.
Repeat steps 1 through 3 until all of your disk drives are installed.
Figure 8. Disk drive mounted in a drive carrier
mounting screw
This completes disk drive installation. Go to "Task 4: Making Data and
Management Connections" on page 9.
mounting screw
VessJBOD supports disk drive hot-swapping. To avoid hand
contact with an electrical hazard, do not remove more than one
drive carrier a time.
Disk drive
Caution
8