Task 2: Mounting Vessjbod In A Rack - Promise Technology VessJBOD 1730 Guide De Démarrage Rapide

Task 2: Mounting VessJBOD in a Rack

The VessJBOD subsystem installs to the rack using the available mounting rails.
You can also use your existing rails.
Figure 4. VessJBOD 1740 or 1840 mounted in a rack with the available rails
Vertical Rack Post
Handles mount
outside the rack post
To install the VessJBOD subsystem into a rack with the available mounting rails:
1. Check the fit of the mounting rails in your rack system.
2. Adjust the length of the mounting rails as needed.
3. Attach the mounting rail assemblies to the outside of the rack posts, using
the attaching screws from your rack system.
Be sure the support is on the bottom facing inward.
4. Square the rail assemblies in the rack.
5. Tighten the adjustment screws and the attaching screws.
• At least two persons are required to safely lift, place, and
attach the VessJBOD subsystem into a rack system.
• Do not lift or move the VessJBOD subsystem by the handles,
power supply or the I/O module. Hold the subsystem itself.
• Only a qualified electrician who is familiar with the installation
procedure should mount and install the VessJBOD
subsystem.
• Be sure all switches are OFF before installing the VessJBOD
subsystem or exchanging components.
Task 2: Mounting VessJBOD in a Rack
VessJBOD subsystem
Mounting rails mount
outside the rack post
Cautions
5