Change Therapy Mode - Medela Invia Liberty Mode D'emploi

Change therapy mode

The settings can only be changed when the pump is in the Administrative mode.
The settings possible to change are, Unit pressure, Air leakage volume, Constant and Intermittent modes,
intermittent times, language and time zone. Pump number, pump run-time and pump version can only be
viewed but not changed.
1. To enter the Administrative mode, unlock the display,
press and hold [
2. To change the therapy mode, press
[ 3 seconds ] to put the Invia Liberty pump into the Standby
mode.
Constant mode – C
The default therapy mode is Constant.
3. To change from Constant mode to Intermittent mode,
press [
Intermittent mode – I
The default times for Intermittent mode are 5 minutes on and
2 minutes off.
4. To change from Intermittent mode to Constant mode, press
[ ] "Change to Constant"
1 minute after the last button has been pressed,
➡
the Invia Liberty pump switches into Patient mode automati-
cally and the display is locked.
1 minute after the last button has been pressed,
the backlight turns off. When pump alarms or any button is
pressed the backlight will illuminate.
], and then press [
]
"Change to Intermittent"
and press
].
"Standby"
and then press [
"On"
"On" [ ].
].
23