lamber 050F Instructions D'emploi page 12

REGENERATING
(for machines with Water-softener)
If the glasswasher is equipped with a Water-
softener it is possible to Regenerate the water
(water cleaning).
Every evening,
operations, lift the overflow out of the tank,
close the door and push the switch "A" on the
OFF position.
Push the button "R" until the lamp "H" is
lighted. After twenty minutes the lamp "H" is
OFF.
Every 6 days add 1 kg of salt in tablet-form in
the bottle placed on the bottom of the tank.
Attention!: the regeneration start only when
the machine is on the OFF position.
SALT CONTROL
Unscrew the plug of the salt container at the
bottom of the tank and put 1 kg coarse salt tablets
in it.
Clean the gasket and screw the plug.
The lack of sault in the container causes
damages for the machine because of limestone,
besides a defective washing of glasses and
dishes.
DISHES POSITIONING
It is suitable to place dishes, inside the plastic
basket with the concave side facing upwards.
Place mixed cutlery in a vertical position into
the suitable container minding not to cram them
and with handgrips towards the bottom (see
drawing).
CLEANSING AGENTS
Choice of the suitable cleansing agent is an
essential condition if you want to obtain
extremely good washing results as concerns
hygienic results. It is then important to consider
some points. First of all only highly alkaline and
chlorine-active antifoam products, especially
made for industrial dish-washing machines,
after MAINTENANCE
must be used and they must be produced by
well known reliable Firms. Mean concentration
of the cleansing agents in powder must be
1,5÷2,5 g/lt. Mean concentration of liquid
cleansing agents nust be 2÷4 g/lt.
In order to avoid scales and corrosions, put
cleansing agent above water level on the
nearest area of the sucking pump filter, in this
way it will immediately dilute and will not deposit
on the tank bottom.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and
cups you must add a surfactant on water
(Brightner).
Your cleansing agent supplier's will be able to
suggest the most
machine is equipped with a rinse-aid dispenser.
Mean concentration used is 0,15 g/lt.
DESCALING
When hard water is used you can find, inside
the machine and also on dishes, calcareous
sediments which must be removed both for
hygienic and operating reasons by a descaling
operation.
Operating process and frequency of this
intervention are suggested by your cleansing
agent supplier who has suitable products,
generally containing phosphoric acid.
In order to avoid damage to the machine do not
increase the quantities and once operations end
rinse abundantly.
SANIFICATION
At last each 30 days it would be useful to do this
operation which
hygienic conditions of the machine. We suggest
to contact your cleansing agent supplier who will
give you quantity and name of the most suitable
product you can use and that, generally, is an
active chloride powder (100÷200 ppm).
In order to avoid damage to the machine do not
increase the quantities and once operations
end, rinse abundantly.
10
suitable product.
guarantees the complete
Your