Kunzle & Tasin Bona Capricorn Manuel D'utilisation page 15

Starting the Machine
7.
Close the abrasive belt
cover (A).
Then ...
10.
Turn the knob on
the switch from
"0" to "START".
11.
Push the drum control lever
forwards (D) for sanding.
A safety contactor is fitted to the machine. If the power fails when sanding the contactor is activated automatically,
stopping the machine from accidentally starting up when the power is restored. To recommence sanding repeat the
start-up operations described above.
8.
Connect the plug to the
socket.
Hold it in this position until
the motor has reached a
sufficient rotation speed.
12.
To stop the machine, engage
the drum control lever (A) and
release the start handle (B),
which will immediately return
to its initial position.
9.
Standing behind the machine, release the safety lever (A) and
press the start handle (B) until the handle underneath is clasped
(the motor will start). Keeping the start handle pressed, release
the knob (C).
If starting the machine is difficult
in winter when temperatures are
very low, remove the abrasive
belt and start the motor, letting it
idle for several minutes. Replace
the belt and repeat the start up
Release the knob, operations described.
which will automatically
return to work position
"1".
Then ...
13.
Turn the knob from "1" to "0"
Bona Capricorn Manual
15 15
EN