Cleaning The Interior Shell - Wacker Neuson HI400HD D Notice D'emploi

HI400HD D / HD G
7.6

Cleaning the Interior Shell

■ Machine shut down and cool to the touch
Prerequisites
■ Power source disconnected
CAUTION
Hot surface hazard. The machine surfaces may be hot.
► Allow the machine to cool for a minimum of ten minutes before touching it.
When Clean the interior shell prior to the first seasonal use, every 1200 hours or annually,
or as needed.
Procedure Perform the procedure below to clean the interior shell.
1. Remove the fan guard. See topic Cleaning the Fan Blades and Motor.
2. Remove the access panel. See topic Removing the Access Panel.
3. Unscrew and remove the four lift bracket screws (a). Carefully raise and
maneuver the lift bracket (b) away from the machine shell cover (c), resting it on
the rear frame as shown.
4. Remove the six mounting screws and lift the machine shell cover off the machine.
5. Inspect and clean the interior shell using compressed air.
6. Re-install the machine shell cover.
7. Re-install the lift bracket.
8. Re-install the access cover.
9. Re-install the fan guard.
ghi_tx001465gb_FM10.fm
c
b
a
b
wc_gr007776
75
Maintenance