Before Starting - Wacker Neuson HI400HD D Notice D'emploi

Operation
4.22

Before Starting

■ Machine properly positioned
Requirements
■ Power connected to the machine
Checks Before starting the machine, check the following items:
Item
Fuel sight gauge (if equipped)
Fuel tank cap
Gas supply (if equipped)
Operation mode switch
Main control panel
Remote thermostat (if installed)
Ducts and duct adapters
Result The machine is ready to turn on.
HI400HD D / HD G
Task
Check that the fuel tank is full (if applicable).
Check that the fuel tank cap (if applicable) is
secure.
Check that the gas supply lines (if applicable)
have been properly installed.
Check that all valves are in the proper operating
position.
Check that the operation mode switch is in the
OFF position.
Check that proper power supplies have been
connected at the main control panel. See topic
Connecting Power to the Machine.
Check that the remote thermostat has been
correctly installed. See topic Installing the Remote
Thermostat or Thermostat Receptacle Plug.
Check that all ducts and duct adapters have been
properly installed. See topic Installing the Heater
Duct.
48
ghi_tx001462gb_FM10.fm