Removing And Installing The Burner - Wacker Neuson HI400HD D Notice D'emploi

Setting up the Burner
6.2

Removing and Installing the Burner

Note: Although an oil-burning machine (D model) is shown in the photos below, the
procedure for removing the burner assembly on a gas-burning machine (G model)
is similar.
■ Machine shut down and cooled
Requirements
■ Machine properly positioned
CAUTION
Hot surface hazard. The machine surfaces may be hot.
► Allow the machine to cool for a minimum of ten minutes before touching it.
Procedure Before performing any maintenance on the burner assembly, it must be removed
from the machine. Perform the procedure below to remove or install the burner
assembly.
Removal 1. Shut down the machine and allow it to cool.
2. Disconnect the power cord from the power source.
3. Remove the access cover.
4. Remove the screw (d) to disconnect the ground wire (c) from the burner
assembly (b).
5. Rotate the burner assembly counterclockwise and remove it from the flame
head and air tube assembly (e).
6. Perform the required maintenance.
Note: Refer to the maintenance procedures in this manual.
7. Re-install the burner assembly. Refer to the steps below to install the burner
assembly.
Installation 1. Place the burner assembly into the flame head and air tube assembly.
2. Rotate the burner assembly clockwise to lock it into place.
3. Install the ground wire using the screw (d).
4. Re-install the access cover.
e
d
b
c
58
HI400HD D / HD G
b
wc_gr007773
ghi_tx001464gb_FM10.fm