Setting The Gas Selector Valve (G Models) - Wacker Neuson HI400HD D Notice D'emploi

Operation
4.16

Setting the Gas Selector Valve (G models)

Overview Your machine is configured at the factory to operate on natural gas. The gas
selector valve on the gas train allows you to convert the machine from natural gas
to LP as job site conditions require.
Procedure Perform the procedure below to change the type of gas.
1. Ensure that the gas shutoff valve is closed.
2. Remove the gas type label (a) from the handle on the gas selector valve (b).
3. Loosen the screw (c) beneath the label.
4. Turn the handle to the desired position.
5. Tighten the screw.
6. Apply a new gas type label to the handle (extra labels are provided with the
machine).
7. Open the gas shutoff valve.
a
b
HI400HD D / HD G
c
40
ghi_gr007393
ghi_tx001462gb_FM10.fm