Handle Installation - Toto Soirée TL960DDLQR Manuel D'installation Et D'utilisation

Valve Body Installation
1. Insert the valve body from
underside of the sink. Make
sure the COLD side is on the
right and HOT side is on the
left.
2. Place the rubber gasket
underneath the deck adapter
and screw the deck adapter
onto the valve body until it
bottoms out.
3. Make sure the rubber washer
lays flat in the groove of the
deck adapter.
4. Screw the decorative cap onto
the deck adapter. Take care
not to cross thread.
5. Position the valve body as
shown below then tighten the
lock nut.
6. Repeat procedure for the
other valve.

Handle Installation

1. Install handle onto the handle
adapter.
2. Align the handle and secure it
by tightening the set screw.
3. Make adjustment, if necessary
4. Repeat procedure for the
other handle. Make sure the
handle marked C is on the
COLD (right) side and H is on
the HOT (left) side.
INSTALLATION PROCEDURE
4
Rubber gasket
Bottom View
Handle
Handle adapter
Decorative cap
Deck adapter
Rubber washer
Valve body
Lock nut
Hex wrench
Set screw
Handle
adapter
Decorative cap