Kenwood TK-2360 Mode D'emploi page 20

■ Key Lock
Press this key to lock and unlock the transceiver keys.
While Key Lock is activated, you cannot use the Auxiliary,
Side 1, Side 2, and microphone PF keys.
Note: You can still use the following key functions when Key
Lock is activated: Emergency, Lone Worker, Monitor, Monitor
Momentary, Squelch Off, Squelch Off Momentary, Key Lock,
PTT + Autodial.
■ Lone Worker
Press this key to toggle the Lone Worker function ON or
OFF. If the transceiver is not operated for the
pre-programmed time, it will emit a Lone Worker tone.
Subsequently, if no operation is performed while the tone is
emitted, the transceiver will enter Emergency mode.
■ Low Transmit Power
Press this key to change the transmit power on the current
channel to low power, to conserve battery energy.
■ Monitor
Press this key to deactivate QT or DQT signaling. Press
this key again to return to normal operation.
■ Monitor Momentary
Press and hold this key to deactivate QT or DQT signaling.
Release the key to return to normal operation.
■ Paging
After selecting your desired FleetSync channel, press this
key to transmit your PTT List ID, to request a call.
10