General Safety Advice For Electrical Power Tools; Workplace Safety; Electrical Safety - Parkside PABS 12 B2 Instructions D'utilisation Et Consignes De Sécurité

Wear ear protection!
Total vibration (vector sum of three directions) is
calculated in accordance with EN 60745:
Drilling into metal: Vibration emission value
a
uncertainty K = 1.5 m / s
Screwdriving
without impact: Vibration emission value
a
uncertainty K = 1.5 m / s
Note: The vibration level specified in these instruc-
tions was measured in accordance with an EN 60745
standardised measurement process and can be used
to compare equipment. The vibration emission value
specified can also serve as a preliminary assessment
of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions. Re-
gularly using the electric tool in such a way may make
it easy to underestimate the vibration.
Try to keep the vibration loads
as low as possible. Measures to reduce the vibration
load are, e.g. wearing gloves and limiting the work-
ing time. Wherein all states of operation must be in-
cluded (e.g. times when the power tool is switched
off and times where the power tool is switched on but
running without load).
General safety advice for
electrical power tools
all the safety advice
and instructions! Failure
to observe the safety advice and instructions may
result in electric shock, fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term "electrical tool" used in the safety advice
refers to electrical tools powered by mains electricity
Introduction / General safety advice for electrical power tools
< 2.5 m / s ,
2
h,D
2
< 2.5 m / s ,
2
h
2
Read
(by means of a mains lead) and electrical tools pow-
ered by rechargeable batteries (without a mains lead).

1. Workplace safety

a) Keep your working area clean and well
, lit. Untidy or poorly lit working areas can lead
to accidents.
b) Do not work with the device in poten-
tially explosive environments in which
there are inflammable liquids, gases or
.
dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
c) Keep children and other people away
while you are operating the electrical
tool. Distractions can cause you to lose con-
trol of the device.

2. Electrical safety

a) The mains plug on the power tool (or
on the power supply) must fit the mains
socket. Never modify the plug in any
way. Never use adapter plugs with
earthed power tools. Unmodified plugs
and the correct sockets reduce the risk of elec-
tric shock.
b) Avoid touching earthed surfaces such
as pipes, radiators, ovens and refrig-
erators with any part of your body.
There is an increased risk of electric shock if
your body is earthed.
c) Keep the device away from rain or
moisture. Water entering an electrical device
increases the risk of electric shock.
d) Do not use the mains lead for any pur-
pose for which it was not intended, e.g.
to carry the device, to hang up the de-
vice or to pull the mains plug out of
the mains socket. Keep the mains lead
away from heat, oil, sharp edges or
moving parts of the device. Damaged or
tangled mains leads increase the risk of elec-
tric shock.
e) When working outdoors with an elec-
trical power tool always use extension
GB/IE 7