Choosing A Location; Electrical Connection; Power Connection (Power Supply) - Sartorius Secura Notice D'installation Et D'utilisation

Getting Started
Installing the Balance
Inserting (or Removing) Glass Panels
1) Holding it by its rear edge, pull the
draft shield cover up and remove it.
2) Push the three glass panels into the
draft shield guide, all the way to the
front.
3) Then replace the draft shield cover.
In doing so, the draft shield cover
must lock into position.
Balance with No Draft Shield
t
Install the following parts in the order
listed:
1) In-use dust cover (not shown in the
illustration).
2) Install the shield disk and turn this
counterclockwise until it snaps
securely into place.
3) Install the pan support (1) and
weighing pan (2).

Choosing a Location

Select the right setup location:
– Set up the device on a stable, even surface that is not exposed to
vibrations (e.g., weighing stone).
– Maintain free access to the device at all times.
Choose a location that is not subject to the following negative
influences:
– Heat (heater or direct sunlight)
– Drafts from open windows, AC systems, and doors
– Vibrations during weighing
– Heavy traffic areas (personnel)
– Excessive moisture
– Electromagnetic fields
Acclimatization
Condensation from humidity can form on the surfaces of a cold
device when it is brought into a substantially warmer area. To avoid
the effects of condensation, condition the balance for about two
hours, leaving it unplugged from the power supply, before plugging
the balance back into the mains.

Power Connection (Power Supply)

AC Adaptor Assembly
Using the wrong power plug adaptors may cause
fatal electric shock and damage the equipment.
Never insert the power plug adaptor into the socket
separately from the AC adaptor (danger of electric
shock).
t
Use the right power plug adaptor for your mains power supply.
A AC adaptor versions:
Bag Region/Country
a) transparent Europe/EU (except
United Kingdom)
b) yellow United Kingdom
c) blue USA, China, and Japan g) green
d) red Australia
The packaging of AC adaptor module 6971790 with line adaptor g),
h), and i) is labeled with 6971791.
t
Push (1) and slide (2) the power plug
adaptor (A) ) required for your power
supply into the opening of the AC
adaptor module (B). When doing this,
the AC adaptor needs to lock into
position.
Removing/Replacing the AC Adaptor
t
Unlock (1) the AC adaptor and then
detach (2) it.
Power Connection/Safety Precautions
– Only use original Sartorius AC adaptors. The AC adaptor has an
IP rating of IP40 in accordance with EN 60529/IEC 60529.
– Make sure that the voltage rating printed on the manufacturer's
ID label is identical to that of your local mains voltage.
– If the stated supply voltage or the plug design of the AC adaptor
does not comply with your country's standard, please inform the
nearest Sartorius representative.
– The power connection must be made in accordance with the
regulations applicable in your country.
Installation and Operating Instructions Secura, Quintix, Practum
English
Bag Region/Country
e) black India
f) turquoise South Africa
Korea
h) pink Brazil
i) white Argentina
5