sylvac S Depth PRO Mode D'emploi page 11

11. Connecting the instrument
The instrument can be connected to a peripheral via a Power (RS or USB)
cable or Bluetooth
Measured values can be transmitted and the instrument driven using pre-
defined commands (see chap. 12 for a list of the main commands).
12. List of the main command
Selection and configuration
CHA+ / CHA-
FCT0 ...9...A...F
MM / IN
KEY0 / KEY1
MUL [+/-]xxx.xxxx
PRE [+/-]xxx.xxx
STO1 / STO0
ECO1 / ECO 0
LCAL dd.mm.yy
NCAL dd.mm.yy
NUM x...x (up to 20chars) Modify the number of the instrument
UNI1 / UNI0
OUT1 /OUT0
PRE ON / PRE OFF
PRE
SET
REF1/REF2
CST [+/-]xxx.xxx
REFAUTO1 / REFAUTO0 Activate / de-activate automatic reference
SBY xx
BT0/BT1
BTRST
Interrogation
?
CHA?
FCT?
UNI?
KEY?
MUL?
PRE?
STO?
. See page 4 for connecting the Power cable.
®
Change measurement direction
Assign «favourite» function
Change measurement unit
Lock / unlock keypad
Modify multiplication factor
Modify preset value
Activate / de-activate HOLD
Activate / de-activate economic mode
Modify last calibration date
Modify next calibration date
Activate / de-activate change of units
Activate / de-activate contin. data transmission
Activate / de-activate Preset function battery
Recall Preset
Zero reset
Change of active reference
Introduction of the constant value
xx number of minutes before stand-by
Activate / de-activate Bluetooth
Clear pairing information
Current value?
Measurement direction?
«favourite» function active?
Measurement unit active?
Keypad locked?
Multiplication factor?
Preset value?
Status of HOLD function?
module
®
11
E