Operation; Pressure Washer Location - Briggs & Stratton 020223 Manuel D'utilisation

Masquer les pouces Voir aussi pour 020223:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

HOW TO USE PRESSURE
WASHER
If you have any problems operating your pressure washer,
please contact the local Briggs & Stratton service center.

Pressure Washer Location

Pressure Washer Clearance
WARNING
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• Keep at least 5 ft. (152 cm) clearance on all sides of pressure
washer including overhead.
Place pressure washer outdoors. DO NOT place pressure
washer where exhaust gas could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept away from any windows, doors,
ventilation intakes or other openings that can allow
exhaust gas to collect in a confined area (Figure 9).
Prevailing winds and air currents should be taken into
consideration when positioning pressure washer.
WARNING
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide can cause nausea,
fainting or death.
• Operate pressure washer ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
• DO NOT operate pressure washer inside any building or
enclosure, even if doors or windows are open.
Figure 9 — Pressure Washer Clearance

OPERATION

Typical Pressure
Washer Shown
Exhaust Port
How To Start Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
1.
Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.0 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2.
Check that high pressure hose is tightly connected to
spray gun and to pump. See "Preparing Pressure
Washer for Use" for illustrations.
3.
Make sure unit is in level position.
4.
Connect garden hose to water inlet on pressure
washer pump.
5.
Turn ON water, point gun in a safe direction and
squeeze trigger to purge pump system of air and
impurities.
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6.
Attach adjustable nozzle extension to spray gun
(Figure 10).Tighten by hand.
Figure 10 — Connect Nozzle Extension to Spray Gun
7.
Position nozzle in low pressure mode (see "How To
Use Adjustable Nozzle") and squeeze trigger on spray
gun to relieve air pressure caused by turning ON
water.Water will flow out of spray gun in thin stream.
Continue to hold trigger until steady stream of water
occurs and no air remains in system.This will make it
easier to pull start the engine. Release trigger.
8.
Engage safety latch to spray gun trigger (Figure 11).
Figure 11 — Spray Gun with Safety Latch Engaged
10
NOTICE
Safety Latch

Publicité

Table des Matières
loading

Table des Matières