Extension Cord Selection - MIRKA PS 1524 Notice D'utilisation

3. Wear eye and hearing protection. Always use safety glasses. Everyday eyeglasses are NOT
safety glasses. USE CERTIFIED SAFETY EQUIPMENT.
4. Use of this tool can generate and disburse dust or other airborne particles, including
wood dust, crystalline silica dust and asbestos dust. Direct particles away from face and
body. Always operate tool in well ventilated area and provide for proper dust removal. Use dust
collection system wherever possible. Exposure to the dust may cause serious and permanent
respiratory or other injury, including silicosis (a serious lung disease), cancer, and death.
Avoid breathing the dust, and avoid prolonged contact with dust. Allowing dust to get into
your mouth or eyes, or lay on your skin may promote absorption of harmful material. Always
use properly fitting NIOSH/OSHA approved respiratory protection appropriate for the dust
exposure, and wash exposed areas with soap and water.
Terminology
DANGER: indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury.
WARNING: indicates a potentially hazardous situation which, if not avoided, could result in
death or serious injury.
CAUTION: indicates a potentially hazardous situation which, if not Avoided, may result in
minor or moderate injury. or indicates potentially hazardous situation which, if not avoided,
may result in property damage.
NOTE: indicates useful advice for operating the machine for best performance or convenience,
etc.
MOTOR
Always check the nameplate to ensure the A.C. current supply is the correct voltage for your machine.
This tool will operate on voltage within plus or minus 5 percent of that shown on the specification
plate on the tool. Refer to the specification plate on your tool for proper voltage and current rating.
Do not operate your tool on a current on which the voltage is not within correct limits. If an extension
cord is used, make sure the conductor size is large enough to prevent excessive voltage drop which
will cause loss of power and possible motor damage.

EXTENSION CORD SELECTION

Total Extension
25 / 7,5
50 / 15
100 / 30
Cord Length (feet/m) Cord Size (AWG)
1,5 mm
2
2,5 mm
2
4 mm
2
8