MIRKA PS 1524 Notice D'utilisation page 10

Always start at a slower speed and work up to the best speed.
1.
With switch in the locked ON position the thumbwheel may be used to adjust the speed.
2.
The trigger switch can also be used to progressively adjust the speed from zero to the maximum
speed (which is preset by the position of the thumbwheel).
Speed Adjustment
POLISHING OPERATION
WARNING: If the item to be polished is not attached to anything and is light enough to be
moved by the spinning polishing pad, it should be securely clamped or anchored to prevent
it being thrown or flung, resulting in possible injury.
1. Hold the machine firmly by the front and rear handles, making sure the polishing pad is clear
of foreign objects.
2. Start the machine and lower it at an angle so that about half of the polishing pad contacts the
work.
3. Move the machine in long continuous sweeping strokes. DO NOT HOLD POLISHER IN ONE
SPOT Doing so will overheat the surface and cause swirl marks. It is possible to damage and
burn through the paint very quickly.
4. Always be sure motor has stopped before setting the machine down.
MAINTENANCE
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned
with a soft damp cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or
otherwise damage the material.
Wear safety glasses while using compressed air.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug are making good
contact in the outlet. Also, check for blown fuses or open circuit breakers in the line.
10