Sonnenkonig CATANIA Mode D'emploi page 49

LEARNING HOW TO USE THE REMOTE CONTROL
For turning on the receiver, press and hold the "STOP" button for 3 seconds. Light will (if instal-
led) blinks 2 times. They will be synchronized when hear a prolonged signal.
WIRING DIAGRAM OF RECEIVER INSTALLATION DIAGRAM
EN
OF RECEIVER
Receiver
The two cables «to fan neutral» and «to fan live» must be extended to the base if necessary.
The RF wireless technology of the digital transmission is prepared for doing an individual control,
because it is provided with a coincident code index of less than 1/50000. The same code number
is set in the back part of the emitter and the receiver. It is necessary this code number for repair
service in the case of damage.
In wide spaces the receiver can be used in any angle no matter the direction. If the fan and the
lamp are provided of a switch, please set the fan at maximum speed and turn on the lamp before
start using the remote control.
49