Operating Your Fan - Sonnenkonig CATANIA Mode D'emploi

Insert downrod through canopy. Thread wires from motor housingth-
rough downrod.
Remove pin and clip from downrod. Slip downrod into housing yoke,
align hole and reinstall pin and clip. Tighten downrod set screws and
then tighten nuts.
Install ball end into hanging bracket opening. Align slot in ball with tab
in bracket.
Warning: Failure to align slot in ball with tab may result in serious injury
or death.
Warning: to reduce the risk of fire, electrical shock, or personal injury, wire nuts/wire connec-
tors provided with this fan are designed to accept only one 12 gauge house wire and two lead
wires from the fan. If your house wire is larger than 12 gauge or there is more than one house
wire to connect to the two fan lead wires, consult an electrician for the proper size wire nuts/
wire connectors to use.
Technical features:
Speed 1: 150±10%rpm - 26 watt
Speed 2: 230±10%rpm - 45 watt
Speed 3: 330±10%rpm - 75 watt

5 Operating your fan

Models equipped with remote control:
• Select the fan speed by pressing the speed control button on the remote control transmitter (High
speed – Medium speed – Low speed – Off).
• DO NOT attempt to recharge expired batteries. There are special rechargeable batteries, which
are clearly marked with.
• DO NOT dispose of batteries in fire to avoid explosion.
47
EN