Preparation - Sonnenkonig CATANIA Mode D'emploi

4 Preparation

Important: When using an existing outlet box, make sure the box is securely attached to the
building struc-ture and can support the full weight of the fun. Failure to do this can result in
serious injury or death.
A: Close style fan mounting.
Helpful hint: close style mounting is more suitable for ceilings lower than 2.43 m high. The
downrod, hanging ball, and plastic ring are not used in this type of installation Important:
please remove the hanger pin, lock pin and two downrod set screws from the top of the motor
assembly first.
Turn off circuit breakers and wall swich to the fan supply line leads. War-
ning: Failure to disconnect power supply prior to installation may result
in serious injury or death.
Determine mounting method to use.
A: closemount
B: Downrod mount or angle mount. (only some models)
Important: If using the angle mount, check to make sure the ceiling angle
is not steeper than 25°
Check to make sure blades are at least 80 cm from any obstruc-tion.
Check downrod length to ensure blades are at least 2.1 m above the
floor.
Secure mounting bracket to electrical box using screws, spring washers,
and flat washers (size 8 or M5) provided with the electrical box.Use only
proper plug diam 8 mm. Important: if using the angle mount, make sure
open end of mounting bracket is installed facing the roof.
45
EN