IKAR IK G 2 Manuel D'utilisation page 15

Users of IKAR GmbH Safety Harness must carry out a pre use inspection before each and every use:
Checking markers for readability, check the webbing
•
checking the webbing for:
•
cuts, tears and nicks
•
abrasion
•
fraying
•
thinning
•
heat damage
•
mould and paint
•
evidence of chemical & U.V light attack, which will be seen as discolouration, softening or hardening of
the webbing
checking the stitch patterns for:
•
broken or abraded stitches
•
loosened stitching
•
pulled and loops of stitching
•
long tails of thread
checking the metal fi ttings for:
•
rust and pitting
•
cracks
•
distortion / disfi gurement
•
excessive wear
checking the connectors for:
•
rust and pitting
•
cracks
•
distortion / disfi gurement
•
proper arrangement of the slider
checking the bolted triangular fasteners in the fastener on:
•
corrosion
•
fragile places
•
deformation
•
excessive wear
•
safe and fi rm connection
testing of plastic primary and secondary components on:
•
proper location
•
fragile place
•
deformation
•
excessive wear
If any defects or damage is identifi ed the Safety Harness should not be used. It should be taken to a competent
person responsible for the detailed recorded inspections for a thorough visual and Tactile examination.
ENGLISH
Instructions for testing before use:
15