IKAR IK G 2 Manuel D'utilisation page 12

IK G 3 B Two Point (rear "D"-ring and front loops) Fall Arrest Safety Harness
Work Positioning Points (IK G 3 BW / IK G 3 BCW)
IK G 20 Two Point (rear "D" ring and front loops) Fall Arrest Safety Harness
Fall Arrest Attachment Point
Back "D"-Ring marked "A"
The Fall arrest Safety harnesses IK G 1/ IK G 2/ IK G 3 / IK G 20 are approved to EN 361:2002. The harnesses are
designed for the application of its intended use and in connection to other items of the fall protection PPE system
e.g. with Energy Absorbing Lanyards according to EN 354/EN 355
IK G 1 has two basic versions, the version is identifi ed by the suffi x A or B to the harness code.
IK G 2 has three basic versions, the version is identifi ed by the suffi x A, B or C to the harness code
IK G 20 is a version with two front fall arrest attachment loops; the version is identifi ed by the suffi x A or B to the
harness code
IK G 3 is a version with thigh loops and a waist belt
Type A Steel "D" rings, adjustable shoulder straps, chest strap and leg loops via a three bar quick connect buckle.
Type B Steel "D" rings, adjustable shoulder straps, chest strap and leg loops via a sprung loaded quick release
buckle.
Type C Rear steel "D" ring, front attachment loops (must be used as a pair), adjustable shoulder straps, chest strap
and leg loops via a sprung loaded quick release buckle.
All IKAR safety harnesses are manufactured using polyester webbing.
The fall arrest attachment points conforming to EN 361:2002 are all clearly marked with the letter "A", this is the only
point that a fall arrest attachment device should be attached to. In the case of the IK G 2C / IK G 3BC / IK G 20, the
front attachment point consists of two webbing loops (each marked with a "½ A") and both must be attached together
with the attachment device connector should they be used. No other loops or rings must be used for fall arrest.
IK G 1 and IK G 2 (all basic versions), can also be fi tted with an overhead rescue attachment for use in confi ned
space / near vertical applications with restricted space, identifi ed by an "R" suffi xing the version or type. The
overhead rescue attachment has been tested and CEapproved to EN1497:2007 and EN361:2002. However the
rescue attachment should only be used in a fall arrest application when it is attached to an EN360 retractable type
device, with a built in recovery mechanism, with the lifeline coming from directly above. This overhead rescue
attachment point is NOT suitable for use with Energy absorbing Lanyards or guided type fall arresters.
In addition to, or alternatively, the IK G 1 and the IK G 2 (basic versions) can also be fi tted with an integral work
positioning waist belt with two side "D" rings, identifi ed by a "W" suffi xing the version or type. The belt is tested and
CE marked to EN 358:2000.
Fall Arrest Attachment Point
Front Loops marked with
two ½ "A"
IK G 2 IK G 2 / IK G 3
ENGLISH
Fall Arrest Attachment Point
Back „D"-Ring marked „A"
IK G 20
12
Work Positioning Points
IK G 1 / IK G 2