Setting The Volume - Palazzetti ECOFIRE IDRO Manuel D'utilisation Et D'entretien

2.3.2
The data shown on the display when this is in standby mode can be set.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set one of the following values using the
"OFF" •
"1" •
"2" •
"3" •
•
"4"
e) Press
2.3.3
Display brightness when in standby mode can be set.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set the desired brightness (

2.3.4 Setting the volume

a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu [
d) Set the desired volume (OFF, 1 to 5) using the
2.3.5
A good combustion depends on several factors (type of installation, operation and maintenance conditions, type
of pellet etc ..)
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set one of the following values using the
"1"
"2"
"3"
e) Press
20
to go to the setup menu
The display remains on the last operation set by the user;
All operating parameters are displayed cyclically;
The current time is shown
to go to the setup menu
OFF, 1 ... 5
to go to the setup menu
to go to the setup menu
and then press
[12]
and press
and buttons:
and then press
[11]
and press
) using the buttons and press
and then press
13
] and press
buttons and press
and then press
[14]
and press
and buttons:
;
, If the function
;
;
;