Setting The Display Mode; Setting The Volume - Palazzetti ECOFIRE ADAGIO Notice D'installation

8.3.2
Display brightness when in standby mode can be set.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set the desired brightness (

8.3.3 Setting the display mode

The data shown on the display when this is in standby mode can be set.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set one of the following values using the
The display remains on the last operation set by the user;
All operating parameters are displayed cyclically;
The room probe temperature is shown
The current time is shown
e) Press

8.3.4 Setting the volume

The volume of the buzzer can be set based on requirements:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu [
d) Set the desired volume (OFF, 1 to 5) using the
8.3.5 Setting the type of pellets
The type of pellets used can be set:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set one of the following values using the
Small pellets
Medium-sized pellets
Large pellets
e) Press
cod. 00 477 2290 - 04/2015 - Palazzetti - PN - Italy
USE AND MAINTENANCE
to go to the setup menu
[11]
OFF, 1 ... 5
) using the
to go to the setup menu
[12]
and buttons:
to go to the setup menu
13
] and press
to go to the setup menu
[14]
and buttons:
and then press ;
and press
buttons and press
and then press ;
and press
and then press ;
buttons and press
and then press ;
and press
, If the function
47