Installing Iaq Probe Software; Checking The Infrared Connection - Honeywell IAQ Probe Manuel De L'utilisateur

Installing IAQ Probe Software

Select the first option in the IAQ Probe Deluxe installation window:
"Install IAQ Probe Deluxe".
Installation begins the moment you click on the selection, starting the
IAQ Probe Deluxe Setup wizard. Simply follow the instructions until the
final screen and click Finish . The wizard will prompt you to restart your
computer. Restart your computer to complete the installation process.

Checking the Infrared Connection

Before using the software, you must first verify that the Infrared
communication port was correctly installed and is functioning:
• Open the Control Panel and select Phone and modem options
modem is installed, type your country and area code in the space
provided.
• Click on the Modems tab. You
should see Standard Modem over
listed in the Modems
IR link
column. If the IAQ Probe is not
positioned in front of the infrared
reader, you should see the
message Not present displayed in
the Attached To column.
• When you power on your IAQ
Probe and position it in front of
the infrared reader, you should
hear an audio tone indicating that
the reader has detected new
hardware.
• Then, the Not present message
in the Attached To column will change to COM # . This is the number
of the communication port being used. Take note of this number (to
use when configuring the software communication port).
If nothing is displayed, place the operating IAQ Probe directly in front of
the infrared device to enable the unit to be detected.
511403
2/07
IAQ Probe User Manual
Honeywell
IAQ Probe Software
Installation
If no
.
31