Using The Head Support; Top View - Stryker 6253 Manuel D'utilisation Et D'entretien

English

USING THE HEAD SUPPORT

WARNING
The Stryker Evacuation Chair is not recommended for use with suspected cervical, spinal, or fracture injuries.
Before using the head support, the upper control handle must be extended. First, pull the red upper control handle
release cable with one hand. Then, pull up on the handle with the other hand. Release the cable and verify the handle
is securely locked into one of the two available positions.
To attach the head support to the extendable upper control handle:
1. Wrap the loose ends of the strap around the vertical portions of the handle, then feed them through the plastic
loops.
2. Pull tight, and secure the strap to itself.
3. Adjust the height by loosening the strap, moving it to the desired location, and tightening it again.
To support the passenger's head, position at the base of the head. For unconscious, or semiconscious passengers,
secure the head using the other two parts of the strap. Wrap around the passenger's head, and overlap the straps to
the desired tightness to secure. When not in use, these straps can be wrapped back around the handle and attached
to the back of the support.
Return To Table of Contents
1-24
Operation Guide
Upper Control Handle
Figures 33 - 35 - Attaching and using the head support
TOP VIEW
Slide Ring
Head Support
6253-001-166 REV C www.stryker.com