Stryker 6253 Manuel D'utilisation Et D'entretien page 18

English
USING RESTRAINT STRAPS - CONTINUED
To attach the ankle strap:
1. Remove the three plastic pieces from the
strap.
2. Thread the strap through one of the
plastic "D" rings and slide the ring down to
the end of the strap up to the white label.
3. Loop the strap around the front leg of
the chair and pull the loose end of the
strap through the ring.
ring rests against the foot rest tube.
4. Thread the strap through the other "D"
ring.
5. Loop the strap around the other front leg
of the chair and pull the loose end of
the strap through the loop. Pull until the
"D" ring rests against the foot rest tube.
6. Attach the final "male" end clip on the
strap.
Return To Table of Contents
1-16
Operation Guide
Pull until the
6253-001-166 REV C
Figure 9-17 - Attaching the leg strap
www.stryker.com