Transporting The Passenger On Flat Surfaces - Stryker 6253 Manuel D'utilisation Et D'entretien

Operation Guide
English

TRANSPORTING THE PASSENGER ON FLAT SURFACES

Figure 18 - Transporting the Passenger
To roll the Stryker Evacuation Chair over flat surfaces, push and guide the chair from the rear of the passenger, using
either the head end handles or the backrest tube. Lift the chair over and around obstructions with the head end and
foot end lift handles.
In addition to the head end lift handles, the extendable upper control handle can be used in any position to roll and
guide the chair. Extend the upper control handle by pulling the red release cable with one hand, and pulling up on the
control handle with the other. Release the cable to lock the handle in either the intermediate or fully extended position.
Lift the chair over and around obstructions with the head end and foot end lift handles.
CAUTION
Casters are not suitable for all surfaces. Caution should be used at all times.
Return To Table of Contents
1-18 6253-001-166 REV C www.stryker.com