Table des Matières
Publicité
Recording from other devices
To exit the setting screen, press [F2 (CLOSE)].
Connect the device, slide the Line/Mic
switch to [LINE] and "
on the display.
*
Automatic stop is useful when recording CDs etc. that
have more than approx. 2 seconds of silence between
tracks using line recording.
*
Manual stop is useful when recording onto cassette
tapes etc. that need switching from side A to side B
causing silence of more than 15 seconds.
*
When [MENU] is pressed during recording standby in
step
8
on page 31, the synchro recording setting can
be made.
*
If the start of a track is cut from the recording, turn
synchro recording "OFF".
*
Synchro recording cannot be used when using timer
recording for line recording.
Synchro recording:
• Make the synchro recording setting beforehand.
1
Perform steps
*
When connecting to the headphone output terminal
of the external device, the synchro recording may not
function properly.
32
32
" is shown
to
on pages 30 and 31.
1
11
*
When approx. two seconds or more of silence cannot be
detected, or depending on the combination of external
devices, the synchro recording may not function.
Selecting line recording mode
The sound quality can be changed when recording with
line recording. See page 20 for information about recording
modes.
• Press [g STOP/RETURN] to stop the unit.
1
Press [MENU].
2
Press +, – to select "LINE REC" and press
[q OK] to enter.
3
Press +, – to select "LINE REC MODE" and
press [q OK] to enter.
4
Press +, – to select the setting (PCM
sampling frequency/MP3 bitrate) and press
[q OK] to enter.
(The factory setting is
"MP3 192kbps".)
To exit the setting screen, press [F2 (CLOSE)].
Publicité
Table des Matières
