Attaching The Tip; Operating In Auto Mode; Operating In Manual Mode - Silk-n REVIT PRESTIGE ND9002 Mode D'emploi

6.2 Attaching the tip

• Make sure the device is switched off and unplugged
before attaching or changing the tip.
• Always make sure a filter and O-ring are in place. Refer
to the chapter "Replacing the filter" or "Replacing the
O-ring" for replacement if necessary.
1. Attach the desired tip (
2. Make sure the tip is firmly in place before use.

6.3 Operating in Auto mode

Auto mode is only for facial treatments.
1. Press the power button
2. Press the mode button
3. Press the control buttons
Level 1 is the lowest level; while level 3 is the highest level.
4. Press the start/pause button
• Treat the facial area indicated on the LCD display.
The LCD display also shows the countdown of the
treatment time for each facial area. You will hear 2 beeps
when the time elapses.
• Move to the next facial area indicated on the display
after each 2 beeps until the treatment cycle is completed.
• During the treatment, you can press the Start/pause
button and then press the control buttons anytime to
switch to another facial area.

6.4 Operating in Manual mode

Manual mode is for both facial and body treatments. This mode
allows you to follow your own treatment regime. It will not inform
you about treatment times, areas or give you instructions on how
to use it. The timer however, will keep track of the treatment time
that has passed.
1. Press the power button
2. Press the mode button
3. Press the control buttons
Level 1 is the lowest level; while level 3 is the highest level.
4. Press the start/pause button
/ / /
8 9 10
to switch on the device.
5
to select "Auto mode" .
3
to select the desired intensity level.
6
to begin the treatment.
4
to switch on the device.
5
to select "Manual".
3
to select the desired intensity level.
6
to begin the treatment.
4
) to the device.
11
EN
28