Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Electrical connection
• Electrical connection must only be carried out by professio
nal personnel trained and authorised for this purpose.
Sensor luminaire without through-wiring (...ET+HFS)
N
L
...ET + HFS
Sensor luminaire with through-wiring (...ET+LV+HFS)
N
L
...ET + LV + HFS
16
...ET + LV + HFS
DALI version
DALI luminaire with integrated DALI HF motion sensor for
absence-dependent switching and dimming of one or several
DALI luminaires, with and without through-wiring.
Function
Upon detecting a movement in the HF detection range, the
sensor luminaire is switched on automatically and all con-
nected further luminaires (via DALI). Upon expiry of the hold
time and if no further movement is detected, the luminaire
switches off again. Alternatively a dimming level can be set to
which the lighting is dimmed down to, permanently or time-
limited, after expiry of the hold time.
The HF sensor also features a daylight sensor that only swit-
ches on all luminaires when the pre-set light threshold has
been reached or when the level falls below this threshold.
Setting
All of the following functions and parameters can be set via an
infrared remote control LMS HFS RMC (TOC 6122900).
Hold time (TIME)
...see page 13
Signal strength (SENS)
...see page 14
Light value (LUX)
...see page 14
Dimming level (DIM)
The system enables specifying a
residual lighting level following
expiry of the hold time in five
steps between 0% ("off") and 50%.
A special programming mode enables
the dimming level to be set either
permanently or time-limited.
1
4
2
5
3
P
T
D
SENS
DIM
TIME
LUX
17
Publicité
Table des Matières
