Marmitek PowerMid Plus Mode D'emploi page 2

ENGLISCH
Installation of the
PowerMid® Plus
Description of PowerMid® Plus
The PowerMid® Plus kit consists of an 8in1 Remote Control and
a PowerMid® receiver. The 8in1 Remote transmits RF signals
through walls and floors. The PowerMid® receiver converts the
commands of the 8in1 Remote into infrared signals to control
your equipment in other rooms.
With the 8in1 Remote it is possible to control your equipment in
line of sight as well as remotely through the PowerMid® receiver.
Therefore, it is possible to control e.g. the bedroom TV and the
VCR in the living room at the same time.
How to install the PowerMid® receiver
Plug the PowerMid® receiver into a 230V / 50 Hz outlet in the
room where your VCR, Satellite Receiver, Stereo etc. is located
(within 6 meters / 20 feet in line of sight). Point the front of the
receiver (Marmitek label) towards your equipment. Extend the
antenna fully.
The distance between the 8in1 Remote and the PowerMid®
receiver can be 15 to 25 meters (30 to 80 feet), depending on
local circumstances.
In case you cannot place the PowerMid® receiver in line of sight
with your equipment, or in case your equipment is located in a
closed cabinet, add an Infrared Extender (sold separately: MAR-
MITEK INFRARED EXTENDER triple RX570, Art. No. 08920).
Add more receivers (Art. No. 09483) to control equipment in mul-
tiple rooms.
Further on in this manual you will find the instructions regarding
the supplied 8in1 Remote. No extra set-up procedure is needed
for using the 8in1 Remote with the PowerMid® receiver. The
Remote transmits infrared commands as well as RF commands at
the same time. Therefore it is possible to set-up and test the 8in1
Remote by using it in line of sight with your equipment and test
it with the PowerMid® receiver afterwards.
Note: The PowerMid® Plus is not suitable for use with B&O
equipment.
2 3