Continuity Test With Buzzer; Diode Test - Metrix MX 650 Notice De Fonctionnement

Chapter II

4.6. Continuity test with buzzer

600 V CAT I I I 1000A
PEAK
1mS
HOLD
A
V
1000
400
40
40
Hz
REL
750 V
600 V CAT II I
1000 V
600V
Set the switch to .
Connect the red test lead to the "+" terminal and the black to
the "COM" terminal.
Put the touch prods into contact with the circuit to be tested.
If the resistance is less than R < 75 Ω ± 25 Ω, the buzzer will
make a continuous sound.
Note : Always ensure that the circuit is disconnected from the
power supply before measuring continuity! To offset lead
resistance, short circuit the lead touch prods, then press on
Δ
the REL button.

4.7. Diode test

Set the switch to
Connect the red test lead to
the "+" terminal and the
black test lead to the "COM"
terminal.
Put the red touch prod into
contact
anode and the black prod
600 V CAT I I I 1000 A
PEAK
1mS
into
HOLD
A
1000 V
400
cathode.
40
Read
Hz
threshold voltage off the
REL
display.
Note: Always ensure that
750 V
600 V CAT II I
1000 V
the circuit is disconnected
600V
from
before testing diodes! If the
connection is made back to
front, the display indicates
"OL"
enables
distinguish the anode from
the cathode.
MX 650 / MX 655
600 V CAT I I I 1000A
PEAK
1mS
HOLD
A
1000 V
400
Hz
REL
750 V
600 V CAT II I
1000 V
600V
.
with the diode
contact with the
the value of its
the power supply
(Overload); this
the user to
25