Tools Required; Measurement And Marking - Petsafe Staywell 600 Série Guide D'installation

Before installing your pet door
please read the following step-by-
step instructions carefully.

Tools required

• Pencil
• Ruler
• Jig or Keyhole Saw
• Drill
• 7 mm ( / ") Drill Bit
1
4
• Screwdriver
• Tape measure
• Sand paper

Measurement and marking

Measure the belly height of your pet (Fig. 1).
Mark this measurement on the outside of your door and draw a straight
horizontal line (Fig. 2).
Please bear in mind that this line will eventually be the bottom of the
hole you will cut in your door and that the frame of the pet door will be
slightly lower. If necessary, this line may have to be raised slightly to
account for this.
4
FIG.1
Cutting a hole for your pet door
a) In Wood and PVC/uPVC/Metal
The hole that you cut will depend on the size
of pet door you have purchased:
245 mm x 150 mm
Small:
348 mm x 225 mm
Medium:
451 mm x 277 mm
Large:
642 mm x 366 mm
Extra Large:
All dimensions are displayed
height x width (Fig. 3).
Not to scale - for best
results you should refer
to the enclosed
cutting template.
www.petsafe.net
FIG.2
(x)
(X)
FIG.3
Width
Wooden doors
PVC/uPVC/Metal
Height